central dust removal system supplier often checks the grease of the fuel tank of the fan reducer motor and replenishes it in time. The pulse dust collector checks the large film in the pulse valve 1-2 times a year, and the damaged and aging ones should be replaced in time. With the increase of filtration time, the filter bag residual adsorbed dust more and more and affect the normal dust removal work, using the shutdown since shaking vibration for tens of seconds, so that the residual dust attached to the internal surface of the filter bag shake down, dust into the ash bucket, drawer or directly onto the conveyor belt.

The working principle of the central dust removal system supplier is to use the induced draft fan to deliver air volume so that the dust-containing gas enters the box through the inlet of the dust collector. The dust-containing gas is filtered through the filter bag through the gas shunt. The dust is left on the inner surface of the filter bag, and the purified gas enters the induced draft fan through the filter bag and is discharged through the exhaust pipe. After the dust collector works for a period of time, the dust on the filter bag gradually increases the resistance of the dust filter bag, and the dust collector needs to be cleaned, and the dust collector works normally after the cleaning is completed.

Next, we will talk about the structural characteristics of central dust removal system supplier:

First, the cleaning mechanism of the filter component is to use the motor to drive the eccentric wheel, and the connecting rod makes the cloth bag shake and stick to the dust on the outer surface of the filter bag. The control device is divided into two kinds: automatic control and manual control. Automatic control means that when the fan is working continuously, the flight cleaning mechanism will automatically vibrate the ash at a regular time. Manual control means that the flight cleaning mechanism will automatically work after the fan stops, and it will automatically stop after tens of seconds. The dust cleaning motor can also be started at any time according to the need.

Second, the filter parts are made of 208 industrial polyester twill flan cloth filter, each bag is equipped with spring steel wire mesh, the filter effect is good, the replacement of the filter bag is convenient, and the service life is good.

Third, the filter component is equipped with a wide and sealed collapsible access door, so as to repair and remove the filter when necessary.

Fourth, the pulse dust collector can be manufactured according to the actual needs of the design unit or users.

5. Dust collector components adopt a suction structure, which is convenient for dust.

6, the fan parts adopts the imitation centrifugal fan, the air volume is large, the wind pressure is high, the fan characteristic curve is hard, and the noise reduction measures are adopted, and the noise is small when used.

7. The air inlet interface on the upper side of the dust collector can be folded down when needed, so as to increase the use of the air inlet area.

central dust removal system supplier has 16 kinds of specifications, divided into A, B two types. Type A is equipped with ash bucket drawer, type B is not equipped with ash bucket drawer. The lower part of the flange; It is directly connected by the user to the dumping port of the folding bin, the mixing warehouse, the sandblasting box, the belt transportation turning point and other dust collecting equipment on the spot, and the dust is directly recovered.

central dust removal system supplier https://www.kaisenfilter.com/Central-Dust-Collector