Original Title: Dimensional Specifications for Titanium Bars, Plates, Tubes, and Wires Dimensional specifications for titanium rods, plates, tubes and wires The dimension of titanium is one of the basic knowledge of titanium. The dimension of titanium generally refers to the length of titanium. The length of titanium mainly includes length, width, height, diameter, radius,ti6al4v, inner diameter, outer diameter and wall thickness. The length of titanium is measured in meters (m), centimeters (cm), millimeters (mm),titanium filler rod, and so on. They need to understand titanium materials, including titanium rods, titanium plates, titanium tubes, titanium wires and so on, which are rolled from titanium and titanium alloys. Expand the full text 1. Size determination of titanium material It is a useful way to save information. Scale sizing means that the length or length multiplied by width is not less than a certain scale, or the length of titanium plate. Length by width from how many to how many dimensions within the scale of delivery. The production unit can produce and supply according to the demand of this scale. 2. No fixed length It refers to the general length, titanium round bar ,ti6al4v eli, where the product scale (length or width) is within the standard and regular scale, and does not require a fixed scale, it is called an indefinite scale. Indefinite length is also called general length. Metal materials delivered to indefinite length, as long as they are delivered within a regular length scale. For example, if the general length rule of general round titanium not larger than 25mm is 4-10m, the round titanium with length within this scale can be delivered. 3. Fixed length Cut to a fixed size according to the order requirements is called fixed length. When the goods are delivered according to the fixed length, the delivered metal data must have the length specified by the buyer in the order contract. For example, if it is specified in the contract that the goods shall be delivered according to the fixed length of 5m, the delivered materials must be 5m long, and those shorter than 5m or shorter than 5m are unqualified. But in fact, the delivery can not be 5 meters long, so the rule allows positive error, but not negative error. 4. Double scale If it is cut into an integral multiple according to the fixed scale of the order demand, it is called a multiple scale. When the goods are delivered in multiple lengths, the length of the delivered metal material must be an integral multiple (plus a saw cut) of the length (called a single length) specified by the demander in the order contract. For example, if the demander requires a single length of 2m in the order contract, then the length is 4m when it is cut into double lengths, and 6m when it is cut into triple lengths, plus one or two saw cuts separately. The amount of kerf is regulated in the specification. When multiple ruler delivers goods, allow to have positive error only, do not allow to present negative deviation value. 5. Narrow ruler If the width is less than the lower limit of the irregular width of the standard rule, but not less than the narrowest width allowed, it is called a narrow ruler. When delivering goods in narrow sizes, it is necessary to pay attention to the narrow size share and the narrowest size of the relevant normative rules. 6. Short ruler If the length is less than the lower limit of the indefinite length of the titanium tube specification, but not less than the shortest length allowed,titanium round bar, it is called a short ruler. For example, the rule in the specification of titanium pipes for water and gas transportation allows 10% (calculated according to the number of pipes) of short titanium pipes with a length of 2-4m in each batch. 4m is the lower limit of indefinite length, and the shortest length allowed is 2m. Return to Sohu to see more Responsible Editor:. yunchtitanium.com