vacuum cleaner constructor cleaning mechanism is the use of electric motor to drive the pain wheel, the connecting rod to make the bag vibrate and clean the dust on the surface of the filter bag. Its control installation is divided into two kinds: automatic control and manual control. Automatic control means that when the fan continues the task, the single-bag dust collector flying mechanism actively vibrates ash on time, the manual fan dust collector stops the active task of the flying mechanism, actively stops after tens of seconds, and can also start the dust cleaning motor at any time according to the demand, the length of cleaning time is adjusted by the user. Structure performance features: vacuum cleaner constructor, dust catcher is a small volume, dust removal of air purification equipment. Suitable for a variety of vertical dust production points, flexible and convenient, local dust collection, local treatment, can be clean air. The basic structure is composed of dust removal box, centrifugal fan, filter bag (filter cartridge), dust collector and microcomputer controller, etc. The dust is sucked inside the dust collector box by the negative pressure of the fan through the dust suction pipe, and the coarse particle dust is initially filtered by the filter and directly dropped to the dust collector by the filter, and the fine dust is captured by the filter on the outer surface. Clean gas is filtered, decomposed and purified by the filter element into the clean room, and then discharged from the outlet by the fan.
The design principles of vacuum cleaner constructor are as follows:
The required dust removal rate and emission concentration shall be determined in accordance with the prescribed relevant emission standards, indoor health standards and practical possibilities.
Second, according to the characteristics of the dust (dust content, particle size, viscosity, etc.) to determine the flow rate of the flue gas in the dust removal equipment, the required filtration area, and the cleaning method of the filter material and dust removal equipment.
Third, according to the characteristics of the flue gas (temperature, humidity, dew point, pressure, etc.) to determine the structure of the equipment, material selection, as well as the main measures such as ash discharge.
According to the requirements of electrical control and production, determine the distance between all internal components, and keep its distance always in line with the requirements of the gas flow law.
Taking into account the possibility of manufacturing, transportation and on-site construction, vacuum cleaner constructor should have a disintegration plan, and clearly put forward the main technical requirements and construction and installation procedures for the main components, and the quality of construction and installation.
6. Under the condition of achieving the process production and use, the equipment investment required per unit of smoke volume should be as little as possible, the operating cost is not high, the energy saving, the auxiliary equipment and the configuration should be the main equipment of the dust collector, the configuration is correct, and the maintenance is convenient.
vacuum cleaner constructor https://www.kaisenfilter.com/KSG-5-5-A-High-Vacuum-Fume-Extractor.html
